OK, I located an Indak switch, still no luck on the mower deck motors. Further troubleshooting using IH manual and following their continuity tests, I discovered that one of the motors has a faulty/open thermal overload switch. It bench tests fine using pos and neg jumper cables directly to the motor but installed in the harness it won't activate the magnetic switch. I emailed Harold the clean power business who I purchased parts from to see if he has one. The motors are also in series so since one was open, the other doesn't work. Oh well I am glad that I was able to determine the problem although I am not sure yet on the solution. If I just connect the wires and eliminate the thermal protection it would be like the kid I knew in high school who would replace blown automotive fuses with aluminum foil and see where wires were smoking![Smile :) :)](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7)