Archive through February 11, 2010

[rmay]

Hi Guys! I'm looking for some info for my 149. Currently has hydraulic lift for front implements, but nothing for the rear. I would like to add a rear scraper blade, is there a hitch made for this, or do I have to "engineer" one? Any help or site referrals would be GREATLY appreciated!
Thanks for all the expert help I get just by reading other questions!

Roger in SW Michigan

 

[digger]

Roger M.
A 149 with front ports?
I'd like to see a pic of that.
Did you add them?

 

[digger]

Oh yea,
As far as implements go, check out the FAQ's.
http://cubfaq.com/questions.html

Specifically question # 52.
http://cubfaq.com/implements.html

 

[digger]

One more time,
Go here too! LOL
https://www.ihcubcadet.com/IHCCFAQ/

 

[fcurrier]

Roger: This is where profiles come in (and I must admit I'm terribly lax in that area).
Charlie sees front ports. I see a front implement run off a rod between the hydraulic lift arm and a front implement.
That being said, what I think you're talking about needing is the rear lift assembly for your 149. Like manuals, they're available. Properly dressed, that 149 should be all the Cub Cadet you need - except it's nice to have more and not have to change attachments.

 

[dross]

Frank X2

 

[mstetar]

ok i looked in the FAQS but didnt see it, what snow throwers were specific to the WFs i know the QA-XXa throwers will work but dont know what else will work?

 

[jbaker]

Matt I think the only direct hook up is the QA36 and QA42 to the wide frames but I have been told you can use a NF thrower on the wide if you change the subframe

 

[jbaker]

Matt saw your trade post ad so you have cw36 thrower, Someone correct me if I am wrong but all you need to do is change the subframe. I am sure some one told me that here.

 

[mgonitzke]

CW-36 is bolt-on, not QA. And there is no 'subframe'. Making one fit a WF would be very difficult.