2166, runs and stops

[rthompson]

Had a low oil engine stop on my 2166. added oil back to good level now it runs till the engine is warm and stops. when it cools it will start and run until warm.
changed the oil pressure sensor thinking ,well just may be that is the problem, but still stops when engine warms.
it has a kohler 17hp horizontal engine , drive shaft version.
I need to be pointed in a good direction, Thanks

 

[mgonitzke]

Will it turn over after it stops, or does it act like the engine is stuck?

 

[rthompson]

Will it turn over after it stops, or does it act like the engine is stuck?

Engine turns over just fine, no extra noises from the motor Its like there is a safety switch activated. no spark to the plug.
It had run just fine till the low oil and it shut down. give it 3 hours and it will crank

 

[mgonitzke]

Still confused. You say it "turns over fine" but also "give it 3 hours and it will crank". Will it turn over IMMEDIATELY after it dies, or do you have to wait several hours before it turns over?

 

[rthompson]

Still confused. You say it "turns over fine" but also "give it 3 hours and it will crank". Will it turn over IMMEDIATELY after it dies, or do you have to wait several hours before it turns over?

yes the engine turns over but will not start give it a while it will start and quit after it warms up

 

[gary noblit]

James,Just guessing but an overheated coil will do that,but I'm thinking "old school "coils.Your saying no spark when it quits so it's a maybe..

 

[rthompson]

I will check on that . I will have to locate it. I have a wiring diagram but it is as readable as a New York may, maybe as understandable as that map

 

[gary noblit]

James,coil is under shroud.engine schematic will show where.I'm only assuming it's a twin kohler

 

[rthompson]

single cylender . I said 16 hp but it is a 17 hp, I really like the thing so I am hoping to find the problem. It is an older machine but has been a good one.
Thanks for your help

 

[gary noblit]

Have you tested for spark immediately after it quits?

 

[rthompson]

yes, and even changed the plug just in case

 

[gary noblit]

The odds are good it's the coil.Not too expensive ..set gap about .010..old microfitch works perfect for that,if you can find some

 

[rthompson]

Thanks again.
as Scarlet said "Tomorrow Is Another Day"

 

[gary noblit]

Matt I apologize for jumping in...got carried away..

 

[rthompson]

I don't have a problem with anyone that is trying to help. All help is appreciated.
I will check out these suggestions tomorrow and again THANKS

 

[eweiss]

yes the engine turns over but will not start give it a while it will start and quit after it warms up

check spark, none replace the coil

 

[tkhoffman]

I'm wondering if what was thought-out as a low oil shut down was a dying coil from the get-go

 

[mgonitzke]

I'm wondering if what was thought-out as a low oil shut down was a dying coil from the get-go

Especially considering that model is not equipped with a low oil shutdown if I remember right. All of the 2000 series I have encountered with Kohler engines just had a pressure switch that would turn on an ***** light to let you know it's too late to save the engine.