Made some progress

[Jeffery]

Any advice would be greatly appreciated on restoring my first cub 100 and engine ran but dies after I mow for about 10 mins. Are there any high compression set ups out there for ‘k241. And btw I love this little thing.

 

[Jeffery]

getting down to the bones

down to the nitty gritty now

 

[Nopriors]

That is the nitty gritty. Enjoy the journey!

 

[tkhoffman]

Only thought on the engine stalling at a fairly consistant 10 minutes would be to check the fuel tank vent. On all small engine equipment, Spiders like to clog these vents.

 

[Jeffery]

Thank you for advice here’s where I’m at now

 

[tkhoffman]

Thank you for advice here’s where I’m at nowView attachment 158541View attachment 158542View attachment 158543View attachment 158544

Getting some paint some parts. You are heading in the right direction.

 

[wh cc guy]

Looks good, keep up the good work. I see you are heating with kerosene. 7.48 a gallon here in TN. How much in NY?

 

[Jeffery]

Getting some paint some parts. You are heading in the right direction.

Thanks you

 

[kmcconaughey]

Nice progress! As to the engine dying after ten minutes, another cause could be a failing condenser.

 

[dsarow]

Keep the pictures and questions coming,I recommend using a thread restorer ,and replacing any damaged or mushed up fasteners.Also ordering and replacing parts that might be easier while its apart.This is a enjoyable thred to me as I realize the work,my PO did to my 125 to make it a great tractor

 

[Jeffery]

5.30 gallon in ky

 

[dschwandt]

Did you remove the front axle, give the "C" channel the big "squeeze" fix to remove fore and aft play and check the pin and bushings for wear??

 

[Jeffery]

I wasn’t going to but am now and started working on engine tear down look what I found. Guess they ran out of 241 blocks and has Lp head. Going to have to take to machine shop for over bore and valve job. Standard piston so lots of room lol. Looking to set this tractor up for stock class puller for my daughter. That being said how for can I over bore this 301/241? Any advice would be greatly appreciated. Thank you

 

[tkhoffman]

I wasn’t going to but am now and started working on engine tear down look what I found. Guess they ran out of 241 blocks and has Lp head. Going to have to take to machine shop for over bore and valve job. Standard piston so lots of room lol. Looking to set this tractor up for stock class puller for my daughter. That being said how for can I over bore this 301/241? Any advice would be greatly appreciated. Thank youView attachment 158581View attachment 158582View attachment 158583View attachment 158585View attachment 158584

Looking at your dogs pillow, im surprised he/she escaped overspray.

 

[Jeffery]

Lol