Archive through November 18, 2011

[dnielsen]

I need a dash for a 107 or 127 cub cadet.

 

[ajohnston]

I am looking for a plow or blade for my 682.

 

[sbranson]

Hello I am looking for a nice hood ornament for a 100. Does anyone remake them?

 

[thoffman]

<u>FREE!!</u> Fender set for a QL, 16 X 650 X 8 and 23 X 850 X 12 rims and tires, seat mounting bracket for Ql, 102-123 rear fender. Ain't shipping or meeting, just come and get 'em.

 

[nbartee]

Looking for a good steering cap like the one pictured.

 

[msmucker]

Hi,
I am looking for a dead (BORG) dial hour meter for parts.
Thanks

 

[aaytay]

Looking for the transmission from a 55 or 75 Rear Engine Rider. If you've got one of these (white) machines sitting out back, drop me an email.

 

[cstrutzenberg]

Looking for a complete setup for rear sleeve hitch lift assembly for a narrow frame.

Chad Minooka,IL

 

[dsenatore]

Looking for lift lever for my 1650 w/hydraulic lift. Previous owner broke it where the pin goes through the shaft. Can this be re-drilled or is it best to get replacement?
Thanks, David

 

[bcuster]

David, the e-mail address in your profile bounces. If you don’t find a used one – or just want a new fabrication, check out Aaron Schmidt’s website. He makes them and lots of other cool Cub Cadet stuff.

http://www.xtrememotorworks.com/Parts%20Catalog/Cub%20Cadet%20Parts%20List.htm

Search for part #CC-54-004 (a little over ½ way down the page).

 

[elamott]

I am looking for a S/C drive pulley for a 129 hydro.
Earl LaMott

 

[dsenatore]

Bryan,
Thanks for the info. I updated my email address as well.
Regards,
David

 

[dcharette]

I'm looking for a good oil pan for a K341, cast iron or Al.
Thanks
Dave

 

[nbartee]

I've got my steering cap. Thanks to all that replied.

 

[dcharette]

I found an oil pan with one of the sponsors.

 

[sbauer]

Does anyone have rear hanging hardware for a 364 snow blower to mount to a 782 and 982? Thanks

 

[mburhanna]

Looking for snow thrower that will fit narrow frame cub cadet QA-36 or QA42A

 

[oberlin]

looking to buy a 7hp engine for an original Cub serial #44322

 

[aaytay]

I'm looking for a good used vertical-shaft engine. Something near 10hp and preferably a Briggs or Honda with a straight (non-stepped) crankshaft. I'm not interested in a "project" engine, so probably something with relatively low hours.

 

[thoffman]

Looking for blank aluminum IH serial # tags. I've seen them someplace before but can remember where.