Archive through April 15, 2015

[jshuper]

IH Chipper or Shredder model # ?? Can anyone tell me what model of chipper or shredder this is? I found it for sale locally. Thanks

 

[mconway]

ok, if i put too many pics up, i apologize but i feel i owe those who have given me guidance since this is my first resto of a cub deck so here ya go.
a lot better than the old 32 inch

at least i have a seal number to cross reference, trostel, 473 428 r91

the pins drove out fairly easy...no heat, what are the odds?

some factory paint...

yeah, maybe too organized but i know what it's like to lose s#@*...

time to get to work...

 

[mconway]

and i have lots of pics so i get it back together right....and i have access to the manuals.....thanx for all the feed back and i'll keep updating as work progresses...

 

[digger]

Kyle P.
It's a 39P or 59P depending on what size engine it has.

 

[jbaker]

Kyle, jump on that thing

 

[sblunier]

It's a 35P...the 59P has a wider hammer mill housing.

 

[ecaye]

Well guys I finally got a chance to check out the 1650 that was leaking oil. Apparently whoever owned it before I did JB welded the oil pan back together. The pan has a crack from the drain plug over about 2 inches. I probably should know this already but how hard is it to remove the oil pan do, I have to remove the motor?
Thank you for the help

 

[sblunier]

Pull motor, replace pan, do cradle mod, new iso mounts, reinstall engine.....still shakes....it's a 16!!!!!

 

[dvogtvpe]

bigger the engine is the more they shake. make a 50 cube single. they smooth out when you get them over 7000

 

[dschwandt]

Do the 169's have that "shake it baby shake it" problem??

And will the Kirk balance kit cure the problem?

My 1650 shakes a bit but only at certain RPM ranges. WOT is pretty smooth actually.