Wanted To Buy

[htrent]

WTB: Wide frame (149) sub-frame for a front snow blade. I'm in Central KY and can pick up if fairly close or can do Paypal and have it shipped. PM a price or email to: htrent@gmail.com if you have one available. Thanks in advance!

 

[rrschmitt]

Still looking for a good gearbox (4-bolt style) for a #1/#2 rear mount tiller at reasonable cost. Pulleys would be a plus. Contact via email in my profile. Thanks.

 

[aewald]

Wanted: Wide Frame Snow/Dirt Plow. Looking for it to be shipped if possible Contact via my email on my profile. Located in NE Nebraska. Thanks very much!

 

[rbeem]

Want to Buy.
54” power angle Haban
Power angle kit for IH blade
Madison WI to Waterloo IA
Or pick up at Rockford Plow day.

 

[mmasheris]

For what plow Haben or IH? The 1'' cyl is the same IH has different mounts

 

[rbeem]

(2) different wants.
(1) Complete Haban power angle plow.
(1) Hydraulic angle kit for my IH 54” plow

 

[rrschmitt]

Found a gearbox for the tiller. Thanks to all who responded.

 

[tsdeese]

Want to find a rear blade for a scrape blade I already have the rock rake just need the blade. Email is in profile.

 

[ksanders]

I have the opposite problem. Have the blade but no rake. Don't want to get rid of it though

 

[rbeem]

Looks like I found all that I sought.

 

[tsdeese]

Looking for a bulb socket for a grote light email is in profile.

 

[kmcconaughey]

Timothy, is the entire bulb socket missing or is it just that the rubber bushing and electrical contact is bad? I was able to repair the electrical contact in the socket on the Grote tail lamp for my Original. I posted some info and photos about it CLICK HERE and scroll down near the bottom of the page.

 

[tsdeese]

The whole socket is missing Kraig

 

[dschwandt]

WANTED: Decent 1x8/9 fiberglass dash cowl that's not all butchered up and broken. Must have nice corners.
Thanks Gang!

 

[cjrolke]

any one have an extra tank mount and straps for a 7hp original? don't need the tank just the mounts and straps

 

[aewald]

Found a plow, thanks!

 

[dmerkle]

I looking for a Kubota gas engine for a Cub Cadet 2182. Contact information is in my profile.

 

[ajtimm]

Hi, I need an deck/implement lift bar thumb clip "thang".
It's the clip that you swing over the release button that lets a snow blade float rather than lock. My arm needs a rest!

THANKS!!! AJ

 

[hydroharry]

Hey AJ - the "thang" you're looking for is Part No. IH-376314-R1, Release Rod Lock - but most of us call it a Wire Bail. It's been NLA from Cub Cadet for quite some time and I see Charlie is Sold Out. I've made a few in the past out of an old gallon paint can handle. Here is a pic I stole from Charlie so you can see what it looks like

 

[digger]

Harry and All,
There's actually a die being made right now for those clips and an order of 400 will be heading out to the frozen north before ya know it.