Rebuilding pto

[Rick Cherry]

I have a 108 that has a 12hp k301. The pto needs rebuilt, need some help locating a kit or parts to do it. It has the 2 triangle springs in the front. Kit I found for $95 seemed to be for the other type. Parts on Cub Cadet site were going to be higher than the $225 a total rebuilt one is. Can I do this myself for a reasonable price,and where to get parts? Or do I dump $225 in one already done? Thanks for the help.

 

[digger]

You can buy the kit and do it yourself,
http://cubfaq.com/mechanical_pto.html
Or I have PTO's for less than 225.00,.

https://www.ccspecialties.org/mptos.html

 

[Rick Cherry]

You can buy the kit and do it yourself,
http://cubfaq.com/mechanical_pto.html
Or I have PTO's for less than 225.00,.

https://www.ccspecialties.org/mptos.html

It has 2 pressure springs. How do I tell if it’s the brake style or not?

 

[digger]

It has 2 pressure springs. How do I tell if it’s the brake style or not?

Post a pic or look at this one, it's a brake style.

 

[Rick Cherry]

Post a pic or look at this one, it's a brake style. View attachment 154122

I don’t think it’s the brake style.

 

[digger]

I don’t think it’s the brake style.

Nope it's not, but it's toast because the bearing it rest on is not in the correct spot on the crank shaft and buggered up the center spring, which in turn made it get way out of adjustment. The bearing has to be dead flush with the end of the crank shaft.
http://cubfaq.com/mechanical_pto.html

 

[Rick Cherry]

Yep. Thanks for all the info. I’m going to figure out everything I need and will be ordering one from you once I save enough pennies or get my wife to give me a loan. So busy right now, cost and time wise, one of yours looks like a nice deal. Thanks again.

 

[digger]

Yep. Thanks for all the info. I’m going to figure out everything I need and will be ordering one from you once I save enough pennies or get my wife to give me a loan. So busy right now, cost and time wise, one of yours looks like a nice deal. Thanks again. View attachment 154129

Yep, that would do it.

 

[HKCooper44]

Make sure that large internal snap ring is in the PTO hub! You can get the assembly in place without it, but without it you'll never get the hub and bearing in the proper location on the shaft!! Been there; done that!!