Model 100 fuel line

[tsdeese]

Are the fittings that use the rubber sleeves are they still readily available?

 

[kmcconaughey]

If you are referring to this part, then yes. CC Specialties carries them. See their link at the top of the page. Or click HERE for their website.

 

[tsdeese]

Sorry kraig should’ve made my self clearer I’m talking about the brass fittings

 

[digger]

Sorry kraig should’ve made my self clearer I’m talking about the brass fittings

They are NLA. You'll have to find used somewhere.

 

[kashaver]

I know it is not 'stock' but:

I just used two regular hardware store compression elbows, 1/4" compression on one end, 1/8" male pipe thread on the other. Then bent a piece of 1/4" copper tubing to go between the fuel bowl and the carburetor. If copper for fuel line scares you, you can also make it out of 1/4" brake tubing.

 

[bfleisch]

I did the same thing Kashaver recommended when I restored my original.

 

[zkoester]

All that rubber piece is, is rubber fuel line. Nothing fancy, don't need brass compression fittings. I believe it's just 1/4" fuel line, just cut a small width of it, slide it on, screw it back down. Works great, have it on my 70 and 100 copper lines

 

[tsdeese]

So the compression fittings will work?

 

[mfrade]

Couple'a rubber O-Rings have always worked for me...