lift rod for blade for 2072

[eknapp]

i have a 2072 cub and am looking for the lift rod(long bar flat both ends with holes each end) i have had no luck finding one. part f

 

[kmcconaughey]

That appears to be for the 54" blade. The lift tube, as it's called in the manual, is basically a length of thick wall conduit with each end flattened and a hole drilled. Here's a photo of the one that was on the blade that my parents used to own.

 

[jkreutner]

Ya I made my own I can measure it or send photo if you wish there is slote in one end.

 

[eknapp]

a picture and measurement would be awesome thank you

 

[eknapp]

That appears to be for the 54" blade. The lift tube, as it's called in the manual, is basically a length of thick wall conduit with each end flattened and a hole drilled. Here's a photo of the one that was on the blade that my parents used to own.

View attachment 135458

that looks good

 

[jkreutner]

Sorry I been gone for awhile here is my measurements 29 inches long and 27 inches center of holes

 

[eknapp]

Sorry I been gone for awhile here is my measurements 29 inches long and 27 inches center of holes View attachment 135631

thank you so much i appreciate this

 

[mpatterson]

I made mine for my 982 when I had a blower on the front of it. Had the local steel yard make me one out of solid rolled steel. They threaded the end and made a threaded clevis and then mashed the other end down nice and drilled it. Turned out really nice for what I needed it for! The joys of not being able to find what you need close enough to ya!