Dash tin decal

[Skip Kmitch]

Recently purchased a complete decal set from Maple Hunter for my 1650. Started the application on the top half of the dash tin and after removing the top covering found the decal to be very inaccurate. The word “CHOKE” is about half way off of the raised area where the word should be placed. (See photo)
Anyone have a similar experience?
I had thought Maple Hunter was the place for accurate decals?
Thanks for any comments.
Skip

 

[PACub100]

No experience with them but I'd definitely contact them...

 

[ariley]

It looks good to me. The choke knob is centered above the complete group of "CHOKE" and the choke symbol.

 

[PACub100]

It looks good to me. The choke knob is centered above the complete group of "CHOKE" and the choke symbol.

Look closer...the lettering isn't on the raised area where it should be.

 

[bfleisch]

I used them for my Original and had no problem with the set I received

 

[dschwandt]

Yep!!
Been there and done that and not happy either..
126 and 104 same $hit
Looks like he!!
You can tell they never even tried fit and finish on a real dash tin for the models they were replicating.

Rant over....for now

 

[ariley]

Look closer...the lettering isn't on the raised area where it should be.

Oops, I see now what you are referring to. Yes, I would complain to them as well.

 

[Skip Kmitch]

Look closer...the lettering isn't on the raised area where it should be.

To Maple Hunters credit, I asked for and received a new dash tin decal. The word CHOKE on the new decal is about a quarter inch lower - where it should be.
Skip

 

[PACub100]

 

[ariley]

Great!