Archive through January 05, 2012

[digger]

Troy R.
The cylinders are not even close to being the same.
Also, in the manuals section, there's the installation instructions for the angle kit.
http://www.ccmanuals.info/blades.html

 

[trutherford]

What is the stroke of the right cylinder then

 

[rciminieri]

Marlin H. Thanks for the help. I do appreciate it greatly.

 

[gbailey]

does anybody have dimensions for a narrow frame hitch pin, and what size are creeper mounting bolts on a 122?}

 

[rmcshane]

Here's some before and after pics of the 126 that Marlin H and I saved from the scrap a few weeks ago. Over break I but in a new 12hp Kohler K301 engine in it and it works great. It turned out to be a good project. Especially since it has rear pto.

 

[digger]

Troy R.
Well then it's 8 3/8" fully extended!

 

[digger]

Gary B.
Which hitch pin are you referring to?
If your asking about what attaches it to the tractor, they are 1/2" x how ever long you need depending on if you have a double bracket setup or not.
If your talking about the single that you attach implements to the hitch with, they are 5/8".

The creeper bolts according to the Parts Lookup at the top of the page are 3/8-16 X 7/8 Hex Hd Cap.

 

[memorgan]

Ryan, love it when you get one like that and in a matter of hours its runnin again, Should make a good work horse, good job!!!!

 

[ljones]

My 122 blew its front crank seal and covered me in oil

now I have to get the stubborn pto clutch off

 

[memorgan]

For you Cubbers lookin for snow work, I just read where Cordova Alaska has had 18 FEET in the last week, Any body have a really BIG thrower!!!