Archive through December 07, 2009

[lpalma]

Kohler points. 47 150 01 Fit K91-341 engines and KT17-20
5 for $35.00 $4.95 shipping to your door.

Kohler condenser for K 91,161,181 241,301 magneto engines
47 147 013 for 20.00 + $4.95 shipping to your door.

 

[lpalma]

Kohler Head gaskets. 45-041-17s
Fit K 341 and M16.$8.00 each plus $4.95 shipping to your door.I have 3 of these.

 

[cwiglesworth]

HYDRAULIC ANGLE CYLINDER for SNOW PLOW. Comes with brakets, but hoses and fittings not included. Great condition, not bent! Both brackets included. $200 plus shipping from Kansas. (913)220-5862 or email [email protected]

 

[ksanders]

12hp K301 motor. Has everything including carb, air cleaner, coil, correct big gas tank, working starter, and even front pto. I put gas and a battery on it this past week and fired it right up. There was no smoke. The carb is gummed up and I had to run with the choke. It set there and idled normal with the choke on for a few minutes before I tested everything. I couldn't hear it at high idle or anything, so it's still as-is, but it was being used to cut all last year by PO. $150 complete

Also have a K301 that ran strong until removed this past summer. Always had the slightest noise when hot at high idle, but ran strong. $75

 

[mharrison]

Sale on new gold and navy blue sleeveless kids tshirts embroidered with the hood logo from an original. $4.00 each plus priority mail. Sizes are 2-4, 6-8, 10-12 and 14-16. We have a dozen or so in each size. Questions are welcome!

 

[mharrison]

Sale on oops silk screened dark gray 100% preshrunk cotton short sleeve tshirt. Has hood logo from an original silk screened on the front left crest.(not pictured) Pictured is the full back silk screened with the original and the words IH Cub Cadet Original underneath. This is an oops tshirt as the tractor is yellow and it was supposed to be gold. The t-shirts are $8.00 each plus priority mail. We have mens size small, medium, large, extra large, double extra large, triple extra large and a couple of quadruple extra larges.

 

[kmcconaughey]

Shirtman, looooong time no post! I saw your setup at Red Power in Madison, I was going to say hello but you were VERY busy. I would have bought a shirt from you there but by the time I found your display I was out of money.

Better put my name on two of those cool gray Cub Cadet T-Shirts, I'll email the size and address shortly.

 

[avanwettering]

Selling a M20 Kohler (short block) out of a 2082 cub. Had it running on 1 cyl but has a broken rod on the other cyl. You are buying block, crank and internal parts. $40.00 picked up in Rochester, Minn or pay actual shipping.

 

[jott]

Front tires I posted a while back <u>ARE SOLD</u>

 

[fcurrier]

...and that's going to be about the extent of Frank's Christmas...

 

[towens]

For Sale: 1963 Ih Cub Cadet. This tractor runs and drives great. A little smoke on idle. transmission shifts very well into all three forward gears and reverse. Newer front tires and Newer rear ag's. Minor paint damage from hood on front cast. The key is wired backwards, when the key is in the position to take the key out the switch is "ON",When the key is locked in the switch is "OFF".
$650 obo picked up in Catawba County, NC}

for pics go to
http://ihcubcollector.webs.com/1963cubcadetoriginal.htm

<font size="+2">Price Drop to $650</font>

 

[gfedwards]

The Cub Cadet "super steer" axle setup has been sold. Thanks.

 

[mharrison]

Sale on some deep gold long sleeve twill shirts. However all we have left is mens medium and large. Pictured is the hood logo, 70 and the 149. Might have the original and the quiet line also, will have to look. $10 each plus priority mail.

 

[mharrison]

We have gold and navy blue 2XL 3/4 sleeve tshirts(like a baseball tshirt) embroidered with the hood logo. There are three left at $7 each plus priority mail.

Also kids white and gold 3/4 length tshirts in kids 6-8 and 10-12 embroidered with the hood logo. $4 each plus priority mail.

I'll post some parts next time!

 

[racolton]

All came with my Dad's Cub Cadet 682:
42" snow thrower. It's rusty from sitting outside, and the auger has some chunks missing out of the spirals. (I'm not sure which model - it appears to be adjustable for narrow and wide frames, but it may have been hacked up to fit the 682 by the previous owner.)
Rear tiller with 1 extension. Sorry, no right-angle gear box, also rusty from sitting outside.
42" mower deck, I think it has 1 rust through hole. Comes with 1/2 the sub-frame, the mule drive is being used on the 682.
Koehn steel-sided, fiberglass top, glass front window cab.

Take all for $100

(Sorry, I don't have pictures of the snow thrower or tiller - they are on a pallet covered by a tarp.)

 

[tarthurs]

ok guys i have a 104 that im parting out. the motor ran but smoked and the trans worked great. like i said the whole tractor is still here just torn apart so let me know what parts you need and i will get you prices with shipping. you can email me at [email protected] or give me a call at 724 388 0539 thanks and have a merry christmas

 

[tarthurs]

prices for the below mentioned parts range from 5.00 to 100.00 plus shipping thanks

 

[mgonitzke]

Nearly new 42" blade for 1440, 1641, 1863, and 1864 only. Barely used at all. Includes lift rod. $140 or best offer picked up here in Rockford, IL. I'm sick of tripping over it. [email protected]

 

[mharrison]

For sale, what I call a mule drive, from a 1872 garden tractor. Welded in upper right corner. $75

1872 frame, just what you see in the photo. $75

Spindle and pulley from a 50C deck. Spins freely, deck shell rusted out. $50

Pulley cover from a 50C deck. Has one good sized ding in it otherwise it is solid. Has surface rust and is pitted around the edges. Not sure of what to ask, $50?

Buyer to pay actual UPS ground shipping on everything but the frame. You can pick that up here in Florida or I can meet you at the Florida Flywheeler tractor show in Jan or Feb.

 

[tgipe]

still have some cubs for sale. 1200 with rear pto,$500,runs good good shape, 1200 chassis no engine,$150, 1535 3spd with creeper, $350, rough,680 with 44"deck, runs good good shape,$600, call for pictures. 1 815 718 2246, ask for Tim,or email for pictures, [email protected]