WANTED: REBUILDABLE AQS321 BLOCK (14HP)

[dschwandt]

WANTED; Bad news from the machine shop this morning.
They tanked the block I pulled from my Dual stick 1450 and cleaned it up only to find it has a cracked block.
Anyone need a boat anchor??!!

So, I am in search of a good block to replace it with.
The closer to Zip 52041 the better.
Thanks for the ad!
Contact through mm profile please.

 

[rfcampbell]

WANTED; Bad news from the machine shop this morning.
They tanked the block I pulled from my Dual stick 1450 and cleaned it up only to find it has a cracked block.
Anyone need a boat anchor??!!

So, I am in search of a good block to replace it with.
The closer to Zip 52041 the better.
Thanks for the ad!
Contact through mm profile please.

I thought u were going to use a 341 block out of 2 u were going to take to the machine shop Would a 321 block out of a 149 work? I have one that has been bored .020 had valves done lifters adjusted for extra I have a nos kohler .020 piston and rings But a 149 k-321 isn't set up for a electric pto clutch On the pto end on the block it has only one 3/8 bolt hole so the starter/gen arm can attach to the block A aqs 321 block had 4 bolts not just one on the pto end of the block for the electric pto clutch But it is possible to drill 3 more holes in the block [it can be done] so a electric pto clutch can be used

 

[dschwandt]

The pair of 341's are on the way to the shop this AM along w/your crank and 2 others.
I may just do them both if they check out OK.

I have leads on 2 other 321's at present so we are pretty much covered for now.

 

[Adam Olczak]

WANTED; Bad news from the machine shop this morning.
They tanked the block I pulled from my Dual stick 1450 and cleaned it up only to find it has a cracked block.
Anyone need a boat anchor??!!

So, I am in search of a good block to replace it with.
The closer to Zip 52041 the better.
Thanks for the ad!
Contact through mm profile please.

Where was the block cracked? Do you have pictures?
Aside from severe water intrusion that then froze, I didn't imagine these k series blocks would crack under (assumed) normal circumstance.

 

[dschwandt]

Cracked from the intake valve out towards the flywheel side.
I have seen several cracked inn that location.

 

[Adam Olczak]

Yikes.
Thanks for the tip.

 

[dschwandt]

There are pictures somewhere on this site I put up before I posted the want add.
You may be able to find them using my info and the dates just prior to 11/27/19