Linkage Setup on CC129

[Richard Vollman]

Howdy all, replacing the highlighted linkage in my CC129. The PO used a bent rod and wire inits place and it will not adjust properly. I ordered parts and the install seems straight foreword, My only question is; does linkage need to be set to a certain length or do the cams have a baseline adjustment/position before I start adjusting neutral? If weather hold up I hope to install parts in the next couple days. Thanks

 

[elamott]

I am talking about the joint around number 10. There is a retaining clip that has to be removed. D I have to move the hydro. to get to it?
Earl LaMott

 

[dschwandt]

It's gonna be a tight squeeze in there to get a snap ring pliers into.