Archive through April 20, 2013

[dschwandt]

Wanted: Gearbox to tiller drive belt guard for tiller or a good sketch w/measurments to build one. Looks just to dangerous to use w/o one!

Thanks!
Dave S.

 

[thoffman]

Does anyone have any partial 1x8 series decal kits. I'm needing the front IH that goes on the plastig grill and maybe some more. Whatcha' got?

 

[cmiracle]

Wanted- 2 brake backing plates! Can be with or without pads, I need these for my 1200.

 

[cmiracle]

I've found some backing plates, thank yall for the prompt replies!

 

[rdehli]

looking for a good used cat 0 set up for my 782 also a decent front grill for the same TIA

 

[dschwandt]

WANTED: Center tooth /tine for #2 tiller. The one that bolts between the rotary tines.

Thanks!

Dave S

 

[rdehli]

A buddy of mine is looking for a good #2 tiller for a 782 somewhere close to northeast Iowa thnx in advance

 

[tbdavis]

Looking for a 123 in restorable condition. Ideal tractor would have straight sheet metal, correct fiberglass seat and lights. Don't care about engine as I have a fresh 12 to drop in. No rust buckets please. Located in Indianapolis and willing to travel a couple hours or so. Thanks

 

[jjsmith]

As of now I am now longer in need of a rear end for my 1650. Thank you to all who inquired. If my repair doesnt hold I will have to buy one but for now my fingers are crossed. Thanks again, the people here are A-1 in my book

 

[canderson]

WANTED hard cab for my cub cadet 982. within 200 miles of rockford,il. TIA chris

 

[jcarlton]

Looking for a good running tractor to mow with in or near southern illinois. 1-618-513-4378

 

[kjohannes]

Wanted: narrow frame snow blade mount. I recently bought a snow blade with wide frame mount and I have a narrow frame (105) tractor. Would be willing to trade my wide frame mount and some cash for a narrow frame mount. Thanks.

 

[jcarlton]

Deck and mule drive for cc125. 1-618-513-4378

 

[prtombaugh]

WANTED: I'm looking for a narrow frame mount for a Pincor generator. Thought I'd see if someone had one to sell before I have one fabricated. Thanks, Paul T

 

[digger]

Paul T.
Click the Xtreme Motor works button above. Aaron sells them.

 

[prtombaugh]

Thanks, Charlie. He only lists them for wide frames. I will try to get in touch with him and see if he will do a narrow frame version.

 

[rdehli]

looking for a gearbox mount for a #2 tiller thnx much..do not need the gear box just the mount that attaches to the tractor

 

[masmith]

I am looking for a 109, 129, or 149. Preferably a 109, very plain. Just need it for grass cutting. Close to Louisville, KY. Email at [email protected] or cell 502-741-6628. Call or text.

 

[rdehli]

looking for a good strong running kohler Mag 18 motor for a project.

 

[dschwandt]

WANTED: shift lever handle for a 125 that's not all hogged out. The one I have just spins around on the shaft.

Thanks!
Dave S.